Filter
Top Products
IPI 100 Series, IPI 200 Series • Installation
Installation
2-2
W
Installation and service must be performed by
authorized personnel only. This product should
be used with a UL approved electrical box. See
“UL Requirements”, below.
N
The MLC 226 IP to which the IPI intercom is connected
must have been shipped after November 16, 2005 and also
have firmware version 1.05 or later to support the IPI. To
set up the IPI you must use the IPI Intercom HelpDesk
.
software.
UL Requirements
1. This unit is not to be connected to a centralized DC power
source or used beyond its rated voltage range.
2. The IPI 100 AAPs or IPI 200 AAPs must be installed in a
2-gang UL listed junction box.
The UL approved electrical wall box (junction box) is
not included with the IPI; the installer is responsible for
obtaining and installing the box.
3. The unit must be installed in accordance with the National
Electrical Code and with local electrical codes.
Installing or Replacing Button
Labels
The button assembly consists of
a clear lens cap, the label and a
white diffuser. To remove a button
assembly and replace a label:
1. Use a small at-blade
screwdriver to gently pry the
button assembly away from
its plunger/base.
INTERCOM
MIC ON
LEVEL
HIGH
MED
LOW
1
2
3
4
IPI 104
PUSH TO TALK
SECURITY
LAB
ADMIN
OFFIC
E
HELP
DESK