Extron electronic IPI 200 Series Switch User Manual


  Open as PDF
of 100
 
IPI 100 Series, IPI 200 Series • Programming and Control
IPI 201/204 SIS
™
Programming, cont’d
5-24
Command ASCII (Telnet)
(host to intercom)
URL Encoded (Web)
(host to intercom)
Response
(intercom to host)
Additional
description
Remapping port designations
For security reasons the network administrator may wish to assign new/different port numbers to the controller’s Telnet, Web browser, and
direct access ports or to disable one or more ports. Typically Telnet uses port 23, Web access is via port 80 (HTTP), and direct access is via
port 2001.
C
Do not set two or more ports to the same port number. Setting two ports to the same number could cause networking conflicts and
will also result in an E13 (invalid parameter) error.
N
If you remap a port, you must set the port number to 1024 or higher, unless you reset the port to the default number or disable the port by
setting it to 0.
Set the Telnet port
map
24
E
{port#}MT
}
W{port#}MT
|
Pmt {port#}
]
Select a number for the port
that will not conict with any
other ports.
Reset the Telnet
port map
24
E
23MT
}
W23MT
|
Pmt 00023
]
This resets the Telnet port to
port 23.
Disable the Telnet
port map
24
E
0MT
}
W0MT
|
Pmt 00000
]
Setting the port number to 0
disables the port.
Read the Telnet
port map
E
MT
}
WMT
|
{port#}
]
Set the Web port
map
24
E
{port#}MH
}
W{port#}MH
|
Pmh {port#}
]
Reset the Web
port map
24
E
80MH
}
W80MH
|
Pmh 00080
]
This resets the Web port to
port 80.
Disable the Web
port
24
E
0MH
}
W0MH
|
Pmh 00000
]
Read the Web
port map
E
MH
}
WMH
|
{port#}
]
 previous next