Filter
Top Products
3-3
IPL T S Series • Connection and Configuration
COM 3
LAN
UID# 093012052
POWER
12V
.5A MAX
COM 2
COM 1
COM 2
Lighting
Control
Ethernet
RS-232
RS-232
RS-232
DVDLaptop
VCR
Remote User
Control and
Administrator
Monitoring
Projector
Extron
MAV 62
Matrix Switcher
TCP/IP
Network
Extron
IPL T S4
Ethernet Control
Interface
Extron
MediaLink Controller
MLC 206
DISPLAY
POWER
VOLUME
MAX/
MIN
VCR
DVD
Laptop
Extron
MediaLink or
Other Controller
Figure 3-2 — Typical IPL T S interface operating configuration
2. Connect the other end of the serial cable to the display or switching device to
be controlled through the IPL T S.
Setting the Internet Protocol (IP) Address
The IPL T S Series units have a factory default IP address of 192.168.254.254. This
IP address must be changed to an address that will operate on your local network.
There are three ways to change the IP address setting:
• Add Device > Auto Config IP option in Global Configurator
• IPL T S unit’s embedded Web pages
• Address Resolution Protocol (ARP) command
Before you begin:
1. Obtain a valid IP address for your IPL T S Series device from your A/V
system’s network administrator.
2. Write down the unit’s MAC address (a 12-digit number) found on a label on
the rear panel of the unit (for example, 00-05-A6-01-0A-74).
3. If the unit is not at it’s factory default IP address (192.168.254.254), perform a
Mode 4 reset:
a. Hold down the Reset button until the Power LED blinks twice
(6 seconds), then release.
b. Press and release the Reset button again within 1 second.
The Power LED blinks quickly four times, confirming the Mode 4 reset,
which returns the unit to its factory default IP address.