Filter
Top Products
3-5
IPL T S Series • Connection and Configuration
Figure 3-4 — Setting the IP address in Global Configurator
Setting the IP address using embedded Web pages
Each IPL T S unit contains an on-board Web server with interactive pages that can
be used to configure the device.
The IPL T S unit must be at its factory default IP address.
To set an IP address via embedded Web pages:
1. Connect an Ethernet crossover cable between the device and a local PC.
2. On the PC, locate the TCP/IP Properties dialog box.
On Windows
®
XP, the TCP/IP Properties dialog box is found at:
Start > My Network Places > right-click to Properties > Local Area Connection
> right-click to Properties > Internet Protocol (TCP/IP) > Properties.
3. Record the current IP address, subnet mask, default gateway and DHCP
settings. You will need this information later to return the PC to its original
TCP/IP settings.
IP Address:
. . .
Subnet Mask:
. . .
4. Enter the following:
IP address: 192.168.254.253
Subnet mask: 255.255.0.0
Default gateway: <blank>