Filter
Top Products
Fluke 434/435
Users Manual
21-4
Figure 21-1. Location of optical interface
When started, FlukeView software scans the PC ports to find the connected Analyzer. It
is not necessary to adjust baudrate of PC and Analyzer.
For other applications communication baudrate can be adjusted as follows: press the
SETUP key, then Function key F4 – USER PREFerence, and then select RS-232 using
the up/down arrow keys and ENTER. Then adjust the baudrate with the left/right arrow
keys and leave the menu with F5 - BACK. Baudrate and COM port number in FlukeView
must be adjusted correctly.
F
1
F
2
F
3
F
4
F
5
Figure 21-2. Analyzer and laptop PC
For correct communication with a printer it is necessary that baudrate and printer type of
Analyzer match with the hard copy device. The Analyzer baudrate and printer type are
adjustable as follows: press the SETUP key, then Function key F4 – USER PREFerence,
and then select Printer using the up/down arrow keys and ENTER. Then adjust the
baudrate with the left/right arrow keys, adjust the printer type with the up/down arrow
keys and confirm with ENTER. Leave the menu with F5 - BACK.
The figure below shows a typical setup with printer DPU-414 and printer adapter cable
PAC91. This setup requires an Analyzer baudrate of 9600 baud.