Filter
Top Products
Fluke 434/435
Users Manual
17-2
e
ENTER
The set of readings to be logged is selectable in the menu under function key F1 –
SETUP READINGS. With the up/down arrow keys you can select five sets of predefined
readings (Default 1 – 5) and two sets of user definable readings (User 1, 2). Table 17-1
gives an overview of the readings available under Default 1 ... 5. This also gives you an
impression of the readings available for logging.
When ready press F5 – OK. The next menu gives you the possibility to change readings
and is explained below. If you don’t want to change readings, press function key F5 – OK
to return to the START menu.
The Change Selections menu as shown in Figure 17-1 has three columns, and is used to
change the set of readings to be logged.
Figure 17-1. Change selections menu
The arrow keys are used to navigate through the menu. The ‘Selected’ column holds the
readings that are used for logging.
In the ‘Category’ column you can make a main selection (e.g. Volt). Depending on this
selection, a number of readings will show up in the ‘Reading’ column (e.g. Vfund =
fundamental voltage). Readings that are already selected have an indication in front. With
the arrow keys you can highlight a certain reading.
With function key F3 – ADD to can add the highlighted reading to the ‘Selected’ column
so that it is used for logging. Figure 17-2 shows the situation that Vfund has been
selected with the arrow keys. Figure 17-3 shows that Vfund is added in the ‘Selected’
column and available for logging.
Figure 17-2. Vfund has been selected