Filter
Top Products
BX400 S1 Operating Manual 117
Hot-plug components
Figure 40: Installing a double-width connection blade
Ê Open the release lever of the connection blade and push it carefully into the
empty fabric as far as it will go (1).
Ê Push the release lever in the direction of the arrow (2) until it clicks into
place.
Removal is carried out in reverse order.
V CAUTION!
If you remove a double-width connection blade and do not replace it with
a new one, you must install the separating clip (see page 116) and two
dummy modules in the empty slot, see page 112.
/
0