Filter
Top Products
15-1
CHAPTER
15
Operator Panel Replacement
This chapter describes how to remove and install the operator panel. The
information is organized into the following topic:
■ “Operator Panel Replacement” on page 15-1
■ “Accessing the Operator Panel” on page 15-4
15.1 Operator Panel Replacement
The operator panel is a cold replacement component. This means the entire server
must be powered off and the power cords disconnected to replace the operator
panel.
Note – If you replace the XSCF unit and the operator panel simultaneously, system
will not operate normally. Execute the showhardconf command or the
showstatus command to confirm that the component replaced earlier is operating
normally, before replacing the subsequent FRU.