Filter
Top Products
Network configuration
You might need to configure certain network parameters on the device. You can configure these
parameters in the following locations:
●
Installation software
●
Device control panel
●
Embedded Web server
●
Management software (HP Web Jetadmin or HP LaserJet Utility for Macintosh)
NOTE: For more information about using the embedded Web server, see the embedded Web
server guide on the device CD.
For more information on supported networks and network configuration tools, see the HP Jetdirect Print
Server Administrator's Guide. The guide comes with devices in which an HP Jetdirect print server is
installed.
Configure TCP/IPv4 parameters
If your network does not provide automatic IP addressing through DHCP, BOOTP, RARP, or another
method, you might need to enter the following parameters manually before you can scan over the
network:
●
IP address (4 bytes) (such as 192.168.1.1)
●
Subnet mask (4 bytes)
●
Default gateway (4 bytes)
Set an IP address
You can view the current IP address of the device from the control-panel Home screen by touching
Network Address.
Use the following procedure to change the IP address manually.
1. Scroll to and touch Administration.
2. Scroll to and touch Initial Setup.
3. Touch Networking and I/O.
4. Touch Embedded Jetdirect.
5. Touch TCP/IP.
6. Touch IPV4 Settings.
7. Touch Config Method.
8. Touch Manual.
9. Touch Save.
10. Touch Manual Settings.
ENWW Network configuration 33