Gateway E-5400 Personal Computer User Manual


 
The system board
31
RIMM modules must be installed symetrically into both channels, that
is, if a RIMM is installed in RIMM-1 (Channel A), the same size, density,
type, and speed RIMM must be installed in RIMM-3 (Channel B), likewise
for RIMM-2 and RIMM-4. If RIMMs are not installed in this manner, the
computer will not boot. Using the encoded part numbers on the RIMM
modules is the best way to make sure that the parts are the same.
To optimize memory performance, RIMM-1 and RIMM-3 must be
populated first.
ECC memory cannot be combined with non-ECC memory.
Continuity Modules (CRIMMs) are required in all blank memory slots. If
CRIMMs are not installed in blank slots, the computer will not boot.
No jumper settings are required for the memory size or type because this
information is automatically detected by the BIOS.
At the time this manual was printed, some RIMM module configurations
were not available for testing or sale. The following chart is not intended
to imply either availability or compatibility. As new RIMM configurations
become available, check with Gateways website (www.gateway.com) for
updated information.
RIMM Modules Total
Memory
2 - 32 MB RIMMs, 2 - CRIMMs 64 MB
4 - 32 MB RIMMs, 128 MB
2 - 64 MB RIMMs, 2 - 32 MB RIMMs 192 MB
4 - 64 MB RIMMs 256 MB
2 - 96 MB RIMMs, 2 - 64 MB RIMMs 320 MB
RIMM-3
RIMM-4
RIMM-1
RIMM-2
Channel B
Channel A
05030.book Page 31 Monday, November 22, 1999 8:23 AM