Filter
Top Products
58
System Components
To install the new front system fan:
1
Place the new front system fan into the recess in the front of the bottom
drive cage. Orient the fan with the label toward the inside of the chassis
(toward the system board), and the fan power cable to the right side of
the drive cage.
2
Secure the fan to the drive cage with the four screws previously removed.
3
Place the bottom drive cage into the chassis under the middle drive cage
and slide it forward so that the support tabs on top of the bottom cage
engage the middle drive cage, then slide it right to align the screw holes
with the holes on the front of the chassis.
4
Secure drive cage with the four screws previously removed. Make sure to
correctly route the fan power cable.
5
Replace the plastic card guide and any add-in cards removed previously.
6
Replace the hard drives into the bottom drive cage.
7
Replace the data and power cables on the hard drives.
8
Plug the fan power cable into the appropriate connector on the system
board.
9
Replace the bezel and close the case as described in Chapter 3.
10
Reconnect the power and modem cords, then turn on the system.
To remove the rear system fan:
1
Turn off the system and disconnect the power cord and modem cord, if
installed.
2
Open the case by following the instructions on page 17. (See “Preventing
static electricity” on page 15.)
3
Disconnect the rear fan power cable from the system board.
05030.book Page 58 Monday, November 22, 1999 8:23 AM