Filter
Top Products
5-2
Changing Function Codes in the RUN Mode (See TABLE 6)
➁
➀
This is the state in which all operation signals ( signal)
[Keypad operation], FWD and REV signals (Terminal operation)
are OFF.
The last keypad display (frequency, amps, volts etc.) flashes
repeatedly.
The mode is switched to Function Code setting mode (All
Function Code settings can be changed).
Each time the key is pressed, the display changes between
indication of a Function Code and its data.
When these keys are pressed while the Function Code is dis-
played, the Function Code number will change. By pressing
them while data is displayed, the data can be changed.
The data is stored and the Function Code advances to the next
Function Code number.
To change other data, repeat the above procedure.
The program mode is ended and the Drive returns to STOP
mode.
Data Setting
Changing Function Codes in the STOP Mode
Keypad and Display Operation Programming
Mode Selection
The Drive has five (5) modes as shown below. The mode can be changed with the keys on the keypad panel.
(1) Stop Mode: Drive stopped (4) Program Mode: Motor Running
(2) Run Mode: Drive operational (5) Trip Mode: Drive system faults
(3) Program Mode: Motor Stopped
RUN
PRG
RESET
PRG
RESET
FUNC
DATA
FUNC
DATA
Are
there any
more functions
to change?
Stop mode
1
2
3
5
4
Stop Mode
Run Mode
All Function Codes
Can Be Changed
Restricted Function
Code Access
Trip Mode
PRG
RESET
PRG
RESET
PRG
RESET