Filter
Top Products
2-1
Section 2
DESCRIPTION, COMPONENT
IDENTIFICATION, and SPECIFICATION
The Drive is available in ratings of 1/4 to 3 HP 200-240 VAC single phase input, 1/4 to 5 HP 200-230 VAC three phase,
and 1/2 to 5 HP 380-480 VAC three phase. The Drive incorporates advanced Pulse Width Modulated (PWM)
"TORQUE VECTOR" control for high starting torque. The Drives are housed in either a NEMA 1 or NEMA 4 type
enclosure and all Drives are furnished with a detachable cover to allow ease of accessing control and power wiring.
Drive operation and Function Code setting is performed from the “Keypad Panel” that features a Digital Display and
6 dual function keys. The 6 function keys are used for Drive programming and operation.
General data and specifications for each Drive are listed on the nameplate attached to the Drive.
Refer to TABLE 1, for complete Drive specification listing.
All models are UL Listed and CSA Approved. CE MARK applies to the 240 VAC single-phase and 480 VAC 3-phase
Figure 2-1. NAMEPLATE DATA IDENTIFICATION
INSPECTION PROCEDURES UPON DELIVERY
Upon receipt of your Drive, inspect the equipment for the following items:
1. Check the nameplate to insure that the specifications correspond to those
ordered, and to application requirements.
2. Inspect the unit for any damage that may have occurred during shipment.
– If shipping damage is found or the wrong Drive is received, contact the
Distributor from which the equipment was purchased.
AF-300M$
™
II
MODEL NO.
SERIAL NO.
INPUT: OUTPUT:
VOLTS VOLTS
*IN CASE OF "L.V. DIRECTIVE 73/23/EEC" FREQ RANGE (HZ)
AMPS HP
FREQ (HZ) AMPS CONT.
PHASE (S) PHASE
ROTATION
MAX 60 SEC. AMPS
INSTRUCTION BOOK GEI-100272 MADE IN JAPAN
7898
IND. CONT. EQ.
69489