Filter
Top Products
Chapter 4 • Working with Quality Center Synchronizer
89
Running Link Tasks
You can run incremental synchronization tasks and full synchronization
tasks in automatic mode, so that the task is run automatically at specified
time intervals. Alternatively, you can run a link task manually. For more
information on link tasks, see “Incremental Synchronizations” on page 41
and “Full Synchronizations” on page 42.
Important Note: When you run a synchronization task, any locked record in
an endpoint is not synchronized. You can check the report at the end of a
synchronization task run to determine if any records were not
synchronized, and why they were not synchronized. If a mapped record was
not synchronized because it was locked during the run, you can update it
by:
➤ Running an incremental synchronization task after the record is
modified again. For information on incremental synchronization tasks,
see “Incremental Synchronizations” on page 41.
➤ Resetting the time stamp. For more information, see “Resetting a Link”
on page 100.
➤ Running a full synchronization task. For information on full
synchronization tasks, see “Full Synchronizations” on page 42.
This section contains the following topics:
➤ “Running Link Tasks in Automatic Mode” on page 89
➤ “Running Link Tasks Manually” on page 91
Running Link Tasks in Automatic Mode
You can run incremental synchronization tasks and full synchronization
tasks in automatic mode. The task is run at time intervals you specify in the
Scheduling tab. This is useful when there are regular changes to the data you
want to synchronize.