Filter
Top Products
Configuration Options
C-23
3162-A2-GB20-40
August 2000
Ethernet (10BaseT) Port Configuration Options
Table C-10. Ethernet Port Configuration Options
Port Use: Version 2
Next 802.3 Version 2 Disable Prev
Ethernet Port Use. Specifies the protocol for the 10BaseT port.
802.3 – IEEE 802.3 protocol is used for the 10BaseT port.
Version 2 – Ethernet Version 2 protocol is used for the 10BaseT port.
Disable – The 10BaseT port is disabled.
IP Address: 000.000.000.000
Next Edit Clear Prev
Ethernet Port IP Address. Specifies the IP address for the 10BaseT port.
Edit – Allows you to edit or display the IP address for the 10BaseT port.
Clear – Allows you to clear the IP address for the 10BaseT port. The IP address is set
to 000.000.000.000.
NOTE: This configuration option is not displayed if 10BaseT port use (ENET Use)
is disabled.
Subnet Mask: 000.000.000.000
Next Edit Clear Prev
Subnet Mask. Specifies the subnet mask for the 10BaseT port’s IP Address.
Edit – Allows you to edit and/or display the subnet mask for the 10BaseT port.
Clear – Allows you to clear the subnet mask for the 10BaseT port. The subnet mask is
set to 000.000.000.000. If the subnet mask is 000.000.000.000, the IP protocol creates
a default subnet mask based on the class of the IP address (Class A: 255.000.000.000,
Class B: 255.255.000.000, or Class C: 255.255.255.000).
NOTE: This configuration option is not displayed if 10BaseT port use (ENET Use)
is disabled.
Default Gateway Address: 000.000.000.000
Next Edit Clear Prev
Default Gateway Address. Specifies the address where messages for other subnets are
sent.
Edit – Allows you to edit and/or display the default gateway address.
Clear – Allows you to clear the default gateway address. The address is set to
000.000.000.000.
NOTE: This configuration option is not displayed if 10BaseT port use (ENET Use)
is disabled.