Filter
Top Products
Configuration
4-4
3162-A2-GB20-40
August 2000
Configuring the COM Port for SNMP or Telnet
Access
To configure the DSU/CSU for SNMP or Telnet access,
H Enable the SNMP agent or Telnet server within the DSU/CSU (see
Appendix C, Configuration Options).
H Configure the COM port.
H Set the Internet Protocol (IP) address and subnet mask needed to access
the DSU/CSU (see Appendix F, IP Network Addressing Scenario).
H Select the link layer protocol (PPP or SLIP) for the port that provides the link
to the SNMP or Telnet system.
H For SNMP links, specify the two community names (and their access levels)
that are allowed to access the device’s Management Information Base (MIB)
(see Appendix C, Configuration Options).
H For SNMP links, configure the device to send traps to the SNMP manager, if
desired (see Appendix C, Configuration Options, and SNMP Traps in
Chapter 5, Monitoring and Testing).
H Specify the Telnet password or SNMP validation options, if desired (see
Appendix C, Configuration Options).