Filter
Top Products
EN
Chapter 2: Printing Tasks 51
Loading Custom-Size Paper in the 500-Sheet Tray
The following instructions are for
loading custom-sizes in a 500-sheet
tray (optional). For supported sizes of
paper, see page A-5. To load standard
sizes, see page 33.
Note
To avoid paper jams, do not load trays
while the printer is printing.
1 Pull the tray completely out of the
printer.
2 Rotate the dial in the tray to Custom.
An error message will appear in the
control panel display if the dial is not
set properly.
Note
Setting the dial adjusts the printer’s
sensors. It does not adjust the guides
inside the tray.
3 To prevent jams, make sure the
paper size setting matches the size
of paper loaded.
4 Load the tray.
5 Squeeze the release on the back of
the rear paper guide. Slide the rear
guide against the edge of the paper.
The front corners of the paper
should be lined up with the marks on
the side guide’s tabs.
Continued on the next page.