Filter
Top Products
'xdb_trans.html', which is usually installed in the
directory /opt/langtools/wdb/doc on HP-UX
systems.
-interpreter interp
Use the interpreter interp for interface with the
controlling program or device. This option is meant to
be set by programs which communicate with GDB using
it as a back end. For example, '--interpreter=mi'
causes GDB to use the gdbmi interface (see “The GDB/MI
Interface” (page 307)).
-write
Open the executable and core files for both reading and
writing. This is equivalent to the 'set write on'
command inside GDB (see “Patching programs”
(page 122)).
-statistics
This option causes GDB to print statistics about time and
memory usage after it completes each command and
returns to the prompt.
-version
This option causes GDB to print its version number and
no-warranty blurb, and exit.
-pid
This option causes GDB to attach to a running process.
-inline
This option causes the debugger to start with the inline
debugging on.
-src_no_g
This option is used to set the limited source level
debugging without compiling.
2.1.3 Redirecting WDB input and output to a file
To redirect WDB input and output to a file, use either of these commands to start the
debugger:
$ script log1
$ gdb
or
$ gdb | tee log1
2.2 Quitting GDB
quit [expression], q To exit GDB, use the quit command (abbreviated q), or
type an end-of-file character (usually C-d). If you do not
supply expression, GDB will terminate normally; otherwise
it will terminate using the result of expression as the error
code.
An interrupt (often C-c) does not exit from GDB, but rather terminates the action of
any GDB command that is in progress and returns to GDB command level. It is safe to
30 Getting In and Out of GDB