Filter
Top Products
Disable network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
● Decreases product-generated network traffic
● Provides only pertinent information on the configuration page
● Allows the product control panel to display protocol-specific error and warning messages
Link speed and duplex settings
The link speed and communication mode of the product must match the network. For most situations,
leave the product in automatic mode. Incorrect changes to the link speed and duplex settings might
prevent the product from communicating with other network devices. If you need to make changes,
use the product control panel.
NOTE: Making changes to these settings causes the product to turn off and then on. Make changes
only when the product is idle.
1. At the product control panel, touch the Administration button.
2. Touch the Network Settings menu to open it.
3. Touch the Jetdirect Menu option.
4. Touch the down arrow until the Link Speed option displays.
5. Touch the Link Speed option.
6. Touch one of the following options.
Setting Description
Auto The product automatically configures itself for the highest link speed and
communication mode allowed on the network.
10T Half 10 megabytes per second (Mbps), half-duplex operation
10T Full 10 Mbps, full-duplex operation
100TX Half 100 Mbps, half-duplex operation
100TX Full 100 Mbps, full-duplex operation
100TX Auto Limits auto-negotiation to a maximum link speed of 100 Mbps
1000T Full 1000 Mbps, full-duplex operation
7. Touch the Save button. The product turns off and then on.
Configure the product to use the network 25