Filter
Top Products
Configuring IP
In addition to the information described below, you can display the following IP information. This information is
described in other parts of this guide.
• RIP information – see “Displaying RIP Filters” on page 7-16.
• OSPF information – see “Displaying OSPF Information” on page 8-39.
• BGP4 information – see “Displaying BGP4 Information” on page 10-84.
• DVMRP information – see the “Show Commands” chapter in the Command Line Interface Reference.
• PIM information – see the “Show Commands” chapter in the Command Line Interface Reference.
• VRRP or VRRPE information – see “Displaying VRRP and VRRPE Information” on page 12-19.
• SRP information – see the “Show Commands” chapter in the Command Line Interface Reference.
Displaying Global IP Configuration Information
To display global IP configuration information for the routing switch, use one of the following methods.
USING THE CLI
To display IP configuration information, enter the following command at any CLI level:
HP9300> show ip
Global Settings
ttl: 64, arp-age: 10, bootp-relay-max-hops: 4
router-id : 207.95.11.128
enabled : UDP-Broadcast-Forwarding IRDP Proxy-ARP RARP OSPF
disabled: BGP4 Load-Sharing RIP DVMRP SRP VRRP
Static Routes
Index IP Address Subnet Mask Next Hop Router Metric Distance
1 0.0.0.0 0.0.0.0 209.157.23.2 1 1
Policies
Index Action Source Destination Protocol Port Operator
1 deny 209.157.22.34 209.157.22.26 tcp http =
64 permit any any
Syntax: show ip
NOTE: This command has additional options, which are explained in other sections in this guide, including the
sections below this one.
6 - 81