Filter
Top Products
Configuring OSPF
ASBR (Autonomous System Border Router)
RIP Domain
OSPF Domain
Figure 8.7 Redistributing OSPF and static routes to RIP routes
USING THE CLI
EXAMPLE:
To configure the HP 9308M routing switch acting as an ASBR in Figure 8.7 to redistribute OSPF, BGP4, and static
routes into RIP, enter the following commands:
HP9300ASBR(config)# router rip
HP9300ASBR(config-rip-router)# permit redistribute 1 all
HP9300ASBR(config-rip-router)# write memory
NOTE: Redistribution is permitted for all routes by default, so the permit redistribute 1 all command in the
example above is shown for clarity but is not required.
You also have the option of specifying import of just OSPF, BGP4, or static routes, as well as specifying that only
routes for a specific network or with a specific cost (metric) be imported, as shown in the command syntax below:
8 - 25