Filter
Top Products
Advanced Configuration and Management Guide
5. Select the source of the routes you want to redistribute into BGP4. You can select RIP, OSPF, Static, or
Connected (directly attached) routes.
6. Optionally enter a metric for the redistributed routes in the Metric field. You can specify a value from
0 – 4294967295. The default is 0.
7. Optionally select a route map from the Map field’s pulldown list.
NOTE: The route map must already be defined. See “Defining Route Maps” on page 10-59 for information
on defining a route map.
8. Optionally enter a weight for the redistributed routes in the Weight field. You can specify a value from
0 – 65535. The default is 0.
9. For OSPF routes, select one of the following to specify the types of OSPF routes to be redistributed into
BGP4:
• Internal
• External 1
• External 2
10. Click the Add button to apply the changes to the device’s running-config file.
11. Select the Save
link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device’s flash memory.
Redistributing OSPF Routes
To configure the routing switch to redistribute OSPF external type 1 routes, enter the following command:
HP9300(config-bgp-router)# redistribute ospf match external1
Syntax: redistribute ospf [metric <num>] [route-map <map-name>] [weight <num>]
[match internal | external1 | external2]
The ospf parameter indicates that you are redistributing OSPF routes into BGP4.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295. The default
is 0.
The route-map <map-name> parameter specifies a route map to be consulted before adding the filter to the IP
route table.
NOTE: The route map you specify must already be configured on the router. See “Defining Route Maps” on
page 10-59 for information about defining route maps.
The weight <num> parameter changes the weight. You can specify a value from 0 – 65535. The default is 0.
10 - 42