Filter
Top Products
Configuring VRRP and VRRPE
rxed vrrp port mismatch count = 0
rxed vrrp ip address mismatch count = 0
rxed vrrp hello interval mismatch count = 0
rxed vrrp priority zero from master count = 0
rxed vrrp higher priority count = 0
transitioned to master state count = 1
transitioned to backup state count = 1
The same statistics are listed for VRRP and VRRPE.
Syntax: show ip vrrp brief | ethernet <portnum> | ve <num> | stat
Syntax: show ip vrrp-extended brief | ethernet <portnum> | ve <num> | stat
The brief parameter displays summary information. See “Displaying Summary Information” on page 12-19.
The ethernet <portnum> parameter specifies an Ethernet port. If you use this parameter, the command displays
detailed VRRP or VRRPE information only for the specified port. See “Displaying Detailed Information” on
page 12-21.
The ve <num> parameter specifies a virtual interface. If you use this parameter, the command displays detailed
VRRP or VRRPE information only for the specified virtual interface. See “Displaying Detailed Information” on
page 12-21.
The stat parameter displays statistics. This parameter is required for displaying the statistics.
This display shows the following information.
Table 12.5: CLI Display of VRRP or VRRPE Statistics
This Field... Displays...
Interface Statistics
Interface The interface on which VRRP or VRRPE is configured. If VRRP or
VRRPE is configured on more than one interface, the display lists the
statistics separately for each interface.
rxed vrrp header error count The number of VRRP or VRRPE packets received by the interface
that had a header error.
rxed vrrp auth error count The number of VRRP or VRRPE packets received by the interface
that had an authentication error.
rxed vrrp auth passwd mismatch error
count
The number of VRRP or VRRPE packets received by the interface
that had a password value that does not match the password used by
the interface for authentication.
rxed vrrp vrid not found error count The number of VRRP or VRRPE packets received by the interface
that contained a VRID that is not configured on this interface.
VRID Statistics
rxed arp packet drop count The number of ARP packets addressed to the VRID that were
dropped.
rxed ip packet drop count The number of IP packets addressed to the VRID that were dropped.
rxed vrrp port mismatch count The number of packets received that did not match the configuration
for the receiving interface.
rxed vrrp ip address mismatch count The number of packets received that did not match the configured IP
addresses.
12 - 27