Filter
Top Products
Advanced Configuration and Management Guide
USNG THE CLI
HP9300(config)# vlan 2 by port
HP9300(config-vlan-2)# untag e1/3 to 1/4
HP9300(config-vlan-2)# atalk-proto
HP9300(config-vlan-atalk-proto)# static e1/3 to 1/4
HP9300(config-vlan-atalk-proto)# router-interface ve 5
HP9300(config-vlan-atalk-proto)# end
HP9300(config-vlan-2)# vlan 3 by port
HP9300(config-vlan-3)# untag e1/1 to 1/2
HP9300(config-vlan-3)# atalk-proto
HP9300(config-vlan-atalk-proto)# router-interface ve 3
To configure the physical interface (e8) to which all outgoing traffic is forwarded, enter the following commands:
HP9300(config-vlan-atalk-proto)# int e1/8
HP9300(config-if-1/8)# appletalk cable-range 400 - 400
HP9300(config-if-1/8)# appletalk address 400.50
HP9300(config-if-1/8)# appletalk zone-name sales
HP9300(config-if-1/8)# appletalk routing
To configure the defined AppleTalk VLAN virtual interfaces ve3 and ve5, enter the following commands:
HP9300(config-if-1/8)# int ve 5
HP9300(config-vif-5)# appletalk cable-range 100 - 100
HP9300(config-vif-5)# appletalk address 100.50
HP9300(config-vif-5)# appletalk zone-name finance
HP9300(config-vif-5)# appletalk routing
HP9300(config-vif-5)# int ve 3
HP9300(config-vif-3)# appletalk cable-range 200 - 200
HP9300(config-vif-3)# appletalk address 200.50
HP9300(config-vif-3)# appletalk zone-name marketing
HP9300(config-vif-3)# appletalk routing
HP9300(config-vif-3)# end
HP9300# write memory
Modifying AppleTalk Global Parameters
You can modify the following AppleTalk parameters at the global level:
• AppleTalk ARP age
• AppleTalk ARP retransmission count
• AppleTalk ARP retransmission interval
• AppleTalk glean packets
• AppleTalk QoS socket (assigns a higher priority)
15 - 16