Filter
Top Products
9. Close the exit cover.
10. Load supplies by following the label loading procedures. You
may notice a different color and texture on the platen roller.
Linerless supplies do not stick to the textured platen roller.
11. Close the printhead assembly and the cover.
12. Turn on the printer.
13. Verify the alignment of the platen roller with the peel bar or
shelf. Press Feed/Cut to position the supply under the
printhead.
Adjusting the Wide/Narrow Knobs
You may need to adjust the two wide/narrow knobs according to
the width of your supply. For supply that is more than two inches,
adjust the knobs to the wide setting. For supply that is two inches
or less, adjust the knobs to the narrow setting. For linerless
supply, use the narrow setting (knobs are up).
You must adjust both of the knobs to
the same position.
Loading Supplies 2-13