Filter
Top Products
3. Press l or r to see the other options. After you display the
option you want, press Enter/Pause. Press Escape/Clear
twice to exit to the Main menu.
Feed Mode
You can use continuous or on-demand printing. On-demand
printing allows you to remove a label before printing the next one.
To change the setting, from the Main Menu, select Setup, then
Supply. Then, follow these steps.
1. Press l or r until you see
SUPPLY
l Feed Mode r
2. Press Enter/Pause to set the feed mode. You will see the
current setting, for example:
FEED MODE
Continuous r
3. Press l or r to see the other option. After you display the
option you want, press Enter/Pause. Press Escape/Clear
twice to exit to the Main menu.
Print Position
This function adjusts where data prints vertically on the supply.
Adjust the print if it is too close to the top or bottom of the supply,
or overtypes the pre-printed area. One dot is 0.0049 inch.
◆
If the data is too close to the bottom, increase the number.
◆
If the data is too close to the top, decrease the number.
4-4 Setting Supply Options