Filter
Top Products
018 Code page selection defined in the field must be 0 (Internal), 1
(ANSI), 2 (DOS 437), or 3 (DOS 850).
025 Data length is too long.
101 Format referenced by batch not in memory.
400 Invalid character following {.
403 Field separator was not found.
409 Printer memory is full. Delete unnecessary formats or graphics
from memory.
410 Parity mismatch.
411 Framing error (baud rate mismatch).
412 Flow control mismatch.
413 Online receive buffer is full. Check for a flow control problem.
611 Font, bar code, or density in the batch does not fit the format.
612 The data in this line of the batch is either missing or does not
match the format.
613 Reference point off supply.
614 Portion of field off supply or there may be an invalid character in
the packet.
703 The printer sensed a calibration of different-sized black marks.
Make sure the correct supply type is loaded.
704 Printer has not sensed a supply mark within the specified number
of inches or is out of supplies. Check the supply tracking, supply
marks, black mark sensor position, and supply roll for binding.
Press Escape/Clear and try to continue printing. Change supply.
10-4 Troubleshooting