Filter
Top Products
Field Replaceable Units
FRU Removal and Replacement
148
Removing the I/O Board
Perform the following steps to remove the I/O board:
1 Pull the ejector handles, as shown in Figure 56.
Figure 56 Removing the I/O Board
2 Slide the board out slowly until it stops, then lift it
straight up.
When replacing the I/O board, line up the t-shaped
standoffs with the large ends of the keyhole slots in the
board, then set the board on the standoffs. Make sure
that the ejector handles are in the fully open position
before sliding the board into place.