Filter
Top Products
Getting Started
10 DMX 400/430 Operator’s Manual
1.6.1 Label Loading Instructions
1. Disengage the Printhead by rotating the Head-Lift Lever
counter-clockwise to the ‘up’ position.
2. Slide the Media Guide to the outer edge and rotate it to the
‘down’ position.
3. Slide the Retainer to the outer edge of the Supply Mount.
4. Place the label roll on the Supply Mount and slide the
Retainer firmly against it.
5. Insert the label stock as shown in Figure 1-6.
6. Rotate the Media Guide ‘up’ and slide it to the edge of the
media.
7. Engage the Printhead by rotating the Head-Lift Lever
clockwise and locking in the ‘down’ position.
8. Set the Media Width Adjustment Cam according to the media
width, (see Table 1-1).
Cam Setting Media Width
1 Up to 1 "
2 Greater than 1", Up to 2"
3 Greater than 2", Up to 3"
4 Greater than 3", Up to 4.1"
Table 1-1 Media Width Cam Settings