Filter
Top Products
Printing Labels
58 DMX 400/430 Operator’s Manual
Char Description Format
m Set metric flag, enter metric mode All references set to metric until reset
n Clear metric flag, return to inch mode All references set to inch mode
O Form edge offset (start of print
position)
Onnnn = 4 digits, in/100 or mm/10
o Cycle cutter
P Enter character dump mode
p Controlled pause
Q Clear all memory modules
q Clear module qx = Module I.D. (Uppercase)
r Select reflective sensor Used for "black-strip" media sensing,
(e.g. continuous tags, butt-cut labels.
Stripe must be printed on back side of
media)
S Slew (feed) speed Sx x = C -I (2 -5 ips) 400
Sx x = C -K (2 -6 ips) 430
s Set up for one print buffer Set for 1 dot buffer processing. Use for
full length dot buffer processing.
T Printhead dot pattern test label
t Test RAM memory module
(Must be in Test Mode)
a bbbK ‘Module Good’
bbb = 256 or 512, for size of module
U Label format field replacement
V Software switch settings Vn n = 4-Label Present, 2-Internal
Batch, 1-Cutter Enable
v Firmware version information Sends version string to Host
W Request memory module information Wx x = F-font, G-graphic, L-label
w Test FLASH module memory Takes about 90 seconds
X Set default module bank Xa a - A = Memory Module A
Y Output sensor values Dumps sensor values status to
RS-232 port
Z Print internal information and dot
pattern
Table 4-3 System-Level Commands (Continued)