Filter
Top Products
Getting Started
DMX 400/430 Operator’s Manual 11
1.6.2 Adjusting Printhead Pressure
1. Disengage the printhead by rotating the Head-Lift Lever
counter-clockwise to the ‘up’ position.
2. Extend the Media Width Adjustment Cam outward from its
mounting bracket until the notch on the cam clears the notch
on the mounting bracket.
3. With the cam in the extended position, rotate it counter-
clockwise or clockwise to the desired width setting. The
numbered notch on the top right corner of the cam identifies
the media width setting. (Figure 1-7 shows the cam being
changed from the four position to the one position).
4. When the cam is set to the desired media width setting,
return it to its rest position. Make sure that the bracket
détente is fully seated in the cams notch.
5. Engage the Printhead by rotating the Head-Lift Lever
clockwise to the down position.
Figure 1-7 Adjusting Printhead Pressure