Filter
Top Products
Setting Up Your Printer
DMX 400/430 Operator’s Manual 17
If a label’s edge is not detected within 12" (305 mm) of stock, the
Printer will stop feeding labels, (if this occurs, refer to Section 1.6
and reload the media). If a label edge is detected, the Printer will
begin to print the Self-Test pattern, see Figure 2-1 or 2-2
(depending on the Printer model) for an example of the Self-Test
Label). After the test pattern has successfully printed, the Printer
must be turned ‘off’ and then turned ‘on’ again to reset the Printer.
TUE JANUARY 25, 1997 Ø9:29 Ø25
VER: DAØ1 - Ø1.Ø1 12/25/93
ROM CHECKSUM U15 FFFF 47-2014-01A
ROM CHECKSUM U19 FFFF 47-2015-01A
MCU CHECKSUM U32 GOOD 46-22ØØ-Ø1C MCU INT RAM CHECKS GOOD
SERIAL PORT BAUD IS 96ØØ MCU EXT RAM CHECKS GOOD
SYSTEM RAM CHECKS GOOD
MODULE CHECKSUM: 7E8B
TRANSFER SWITCH IS OFF
SETUP SW-A 1 2 3 4 5 6 7 8
OFF OFF OFF OFF OFF OFF OFF OFF
SETUP SW-B 1 2 3 4
OFF OFF OFF OFF
ANALOG INPUT VALUES:
PAPER :229 EDGE: 173 REFL : 195 TEMP : Ø62 24VOLT : 198
POT :133 TOFA: 153 RIBN : Ø27 RWND : 013
INCH COUNTER DATE SET: ØØ/ØØ/ØØ
TOTAL LABEL LENGTH IN INCHES: 44
Figure 2-1 DMX 400 Test Label