HP (Hewlett-Packard) 3500, 3700 Printer User Manual


 
Control panel message Description Recommended action
MANUALLY FEED
<TYPE> <SIZE>
alternates with
To use another
tray press
.
There is no paper in the tray and a print
job sent requires a specific paper type
and size that is not currently available
through Tray 1.
Press to print from another tray. See
Configuring trays for more information.
or
Press
for help.
Moving solenoid
alternates with
To exit press
STOP key
The printer is executing a Component
Test and the component selected is
Solenoid.
No action necessary.
Moving solenoid
and motor
alternates with
To exit press
STOP key
The printer is executing a Component
Test and the components selected are
Solenoid and Motor.
No action necessary.
NON HP SUPPLY
DETECTED
alternates with
For help press ?
A new supply has been installed that is
not made by HP. This message is
displayed until an HP supply is installed
or
is pressed.
If you believe you purchased an
HP supply, please call the HP fraud
hotline at 1-877-219-3183.
Service or repairs required as a result of
using non-HP supplies is not covered
under HP warranty.
To continue printing, press
. The first
pending job will be cancelled.
NON HP SUPPLY
IN USE
alternates with
Ready
The printer has detected that a non-
HP supply is currently installed and
(override) was pressed.
If you believe you purchased an
HP supply, please call the HP fraud
hotline at 1-877-219-3183.
Service or repairs required as a result of
using non-HP supplies is not covered
under HP warranty.
ORDER <COLOR>
CARTRIDGE
alternates with
Ready
The identified print cartridge is nearing
the end of its useful life. The printer is
ready and will continue for the estimated
number of pages indicated.
Order the identified print cartridge.
Printing will continue until REPLACE
<COLOR> CARTRIDGE is shown.
Note
Estimated pages remaining is based
upon historical page coverage with this
supply of one percent.
See Supplies and accessories for more
information.
ORDER FUSER KIT
alternates with
Ready
For help press ?
The fuser is near end of life. The printer
is ready and will continue for the
estimated number of pages indicated.
Order the fuser kit. Printing can continue
until REPLACE FUSER KIT is shown.
or
Press
for help.
See
Supplies and accessories for more
information.
136 Chapter 8 Problemsolving ENWW