Filter
Top Products
Procedure 4: Mount the Hub into a Rack (Optional) 31
Installation
Figure 12 Hub Correctly Installed in a Rack
12. Plug the PDU cable into the cabinet PDU when you are ready to power on the hub. The
hub finishes the self-test in less than 15 seconds. Verify that the hub passes the self-test.
If the Fault LED (amber) stays on after self-test, the hub failed. Refer to chapter4,
Troubleshooting, or contact an HP service representative for assistance.
If the Power LED is not lighted, refer to chapter4, Troubleshooting, or contact an HP
service representative.
13. Reinstall filler panels over the plenum shroud.