Filter
Top Products
If Firmware Upgrade Appears to Fail 83
Troubleshooting
After a few minutes, the transfer prompt appears; for example:
Done, memory range [$00001000:$00004FFF]
Ready to transfer Hub-Controller code from RAM to FLASH
Note, once started, this step must not be interrupted
Press Enter to start, control-C to cancel
The values displayed for memory range represent low-level diagnostics; the values
displayed in the status message can be different from the values shown here.
4. Press <ENTER>. Additional progress indicators and status messages appear; for
example:
--+
$..................................................................
.........
************************
The hub is automatically rebooted and additional messages appear:
Rebooting to make sure download was successful...
DRAM test (this will take about 10 seconds) > passed
SEEPROM test (this will take about 1 second ) > passed
FLASH checksum (this will take about 2 seconds) > passed
Press Enter key for Boot Menu, Agent boot in 6 seconds
Then the Main menu appears.
Fibre Channel Hub Model Number: HP3724A
Device Agent Version: 02.04
Hub Controller Version: 02.02
Agent Boot PROM Version: 01.04
Status of Device Agent self-test: passed
Status of Hub Controller self-test: passed
1. Reset hub and run self-test
2. Set Networking parameters
5. Verify that the Device Agent and Hub Controller versions you reinstalled appear in the
Main menu.
6. See Updating the Hub Firmware on page48 to upgrade to the new firmware versions.