Filter
Top Products
Managing Tape Drives
L700 (CTL700) Installation and User’s Guide—527338-004
9-6
Bring Down a Cartridge Tape Drive
STOP Command Syntax
The syntax for the STOP command is:
OUT file-spec
directs all SCF output generated for this command to the specified file.
FORCED
specifies that the command should be executed without any interaction
with the user, even if files are open on the device. SCF does not prompt
the operator for confirmation.
SEL state
specifies that the command should be applied only to objects that are in
the specified state.
object-spec
specifies one of the following combinations of object type and object
name
Wild-card characters are supported.
STOP SCSI Command
This subsection describes the STOP SCSI command. The STOP SCSI
command stops access to the specified Open SCSI device. The command
syntax is:
$device-name | $1dev
specifies the name or logical device number of the device.
-P | -B
specifies whether the path being stopped is the primary (-P) or backup
(-B).
STOP [ /OUT file-spec/ ] [object-spec
]
[ , FORCED ]
[ , SEL state ]
Object Type Object Name
SCSI $device-name
SCSI $device-name-path
TAPE $tape-name
STOP SCSI {$device-name | $1dev} [ -P
| -B ]