Filter
Top Products
Configuring the CTL700 Tape Library for the
NonStop NS-Series Server
L700 (CTL700) Installation and User’s Guide—527338-004
D-3
Configuring the Control Path
Configuring the Control Path
1. In SCF, issue this command:
SCF> ADD SCSI $scsi, SENDTO STORAGE, PRIMARYLOCATION (group,
module, slot), PRIMARYSAC sac-id, PRIMARYPORTNAME 64-bit-
portname, LUN lun-id
Example:
SCF> ADD SCSI $CTL700, SENDTO STORAGE, PRIMARYLOCATION
(110,2,3), PRIMARYSAC 1, PRIMARYPORTNAME 100000E00D00F000,LUN
0
Table D-2 shows the SCSI ID, router port number, and the LUN address for a tape
library.
2. To start the tape library on the server, issue this command in SCF:
SCF> START SCSI $scsi
Note. LUN in SCF should be 0 for the tape library that is on Bus 0. Lun in SCF should be 2 for
the tape library that is on Bus 1.
Note. PORTNAME in SCF corresponds to the WWP name of the router. This name is located
on the back of the device. See Figure D-2
.
Table D-2. Fibre Channel to SCSI Router LUN Mapping Table
DEVICE SCSI ID Router PORT LUN ADDRESS
Tape Library 3 0 LUN 0
Tape Library 3 1 LUN 2
Figure D-2. Fibre Channel Router Rear View
WWNN: 100000E00200F000
WWPN: 100000E00D00F000
ENET MAC ID: 00:E0:02:00:00:XY
WWN Name
WWP Name
Ethernet MAC ID
(Physical Address)