Filter
Top Products
Introduction
About this guide
1-2
About this guide
This guide explains how to install, configure, and operate the M111 Client Bridge.
Products covered
The manual applies to the M111 Client Bridge (J9389A WW, J9523A Japan).
Important terms
The following terms are used in this guide.
Conventions
This guide uses specific syntax when directing you to interact with the management tool user
interface. Refer to the following image for identification of key user-interface elements and
then the table below for example directions:
Warnings and cautions
Do not proceed beyond a WARNING or CAUTION notice until you fully understand the
hazardous conditions and have taken appropriate steps.
Warning Identifies a hazard that can cause physical injury or death.
Term Description
MSM AP Refers to any HP ProCurve Networking MSM3xx or MSM4xx Access
Point.
Controller Refers to any HP ProCurve Networking MSM7xx Controller, including
both Access Controller and Mobility Controller variants.
Example directions in this guide What to do in the user interface
Select Network > Ports On the main menu select Network and then
select Ports on the sub-menu.
For Password specify secret22.In the Password field enter the text secret22
exactly as shown.