Filter
Top Products
Working with the M111
Managing certificates
3-37
Access level
Type of access assigned to the user:
Read-only: The user has read and notify access to all MIB objects.
Read-write: The user has read, write, and notify access to all MIB objects.
Notification receivers
This table lists all defined SNMP notification receivers. SNMP notifications are sent to all
receivers in this list. To add a new receiver, select Add New Receiver. Up to five receivers
are supported. To edit a receiver, select its link in the Host column.
Host
The domain name or IP address of the SNMP notifications receiver to which the M111 will
send notifications.
UDP port
The port on which the M111 will send notifications.
Version
The SNMP version (v1,v2c, v3) for which this receiver is configured.
Community/Username
For SNMP v1 and v2c, the SNMP Community name of the receiver.
For SNMP v3, the SNMP v3 Username of the receiver.
Security
Use these settings to control access to the SNMP agent.
Allowed addresses: List of IP address from which access to the SNMP agent is
permitted. To add an entry, specify the IP address and appropriate Mask, and then
select Add.
When the list is empty, access is permitted from any IP address.
Active interfaces: Select the checkboxes that correspond to the interfaces from which
to allow access to the SNMP agent.
Managing certificates
Digital certificates are electronic documents that are used to validate the end parties or peers
involved in data transfer. Various features on the M111 make use of certificates for
authentication and/or encryption of data exchanged with peers.