Filter
Top Products
Working with the M111
IP address configuration
3-8
There are several solutions to this problem:
Pre-configure the DHCP server on the network to assign a specific IP address to the
M111. To do this you need to specify the M111 MAC address and a reserved IP address on
the DHCP server. The M111 MAC address is printed on the M111 label identified as
Wireless Base MAC, or listed on the management tool Home or Login page as
Wireless MAC address.
Assign a static IP address to the M111 as explained in the next section To configure IP
addressing. The address must be on the same subnet as the MSM AP to which the M111
will connect.
Define a management IP address. See To assign a management address on page 3-34.
The M111 provides MAC address translation for all devices connected to Port 1 as their traffic
is forwarded across the wireless link. This enables up to 20 Ethernet devices to share the
wireless link, yet at the same time have their own unique IP addresses.
To configure IP addressing
1. Select Network > Ports.
2. Select Bridge port in the table.
3. Under Assign IP address via, select the option you want to use, and select Configure.
4. Specify your settings and select Save, and then from the Bridge configuration page
select Save again.