Filter
Top Products
Configure e-mail settings
Before you can send a document to e-mail, you must configure the device for e-mailing.
NOTE You can also configure the e-mail settings by using the embedded Web server, which
HP recommends. For helpful tips and more about configuring the scan e-mail feature, see the
Embedded Web Server User Guide on the device CD.
For more information on setting up a feature, solving a problem, or discovering how to use this
device, go to
www.hp.com/support/LJM3027mfp or www.hp.com/support/LJM3035mfp.
Supported protocols
The HP LaserJet M3027 MFP models support Simple Mail Transfer Protocol (SMTP). The HP LaserJet
M3035 MFP models support SMTP and Lightweight Directory Access Protocol (LDAP).
SMTP
●
SMTP is a set of rules that define the interaction between programs that send and receive e-mail.
In order for the device to send documents to e-mail, it must be connected to a LAN that has a valid
SMTP IP address. The SMTP server must also have Internet access.
●
If you are using a LAN connection, contact your system administrator to obtain the IP address for
your SMTP server. If you are connecting through a DSL connection, contact the service provider
to obtain the SMTP server IP address.
LDAP
●
LDAP is used to gain access to a database of information. When the device uses LDAP, it searches
a global list of e-mail addresses. As you begin to type the e-mail address, LDAP uses an auto-
complete feature that supplies a list of e-mail addresses that match the characters you type. As
you type additional characters, the list of matching e-mail addresses becomes smaller.
●
The device supports LDAP, but a connection to an LDAP server is not required in order for the
device to be able to send to e-mail.
NOTE If you need to change the LDAP settings, you must change them by using the
embedded Web server. For more information, see
Use the embedded Web server, or see
the Embedded Web Server User Guide on the device CD.
Configure e-mail server settings
Consult a network administrator or internet service provider (ISP) for the IP address or the name of the
SMTP server. Or, find the IP address from the device control panel (see
Use information pages). Then
use the following procedures to manually configure and test the IP address.
Configure the SMTP gateway address
1. From the Home screen, touch Administration.
2. Touch Initial Setup.
3. Touch E-mail Setup, and then touch SMTP Gateway.
110 Chapter 8 Scan and send e-mail ENWW