Filter
Top Products
Control panel message Description Recommended action
or go to www.hp.com/support/LJM3027mfp
or
www.hp.com/support/LJM3035mfp.)
22 Embedded I/O buffer overflow To
continue touch OK
Too much data was sent to the embedded
HP Jetdirect print server.
Touch OK to print the transferred data. (Some
data might be lost.)
22 Parallel I/O buffer overflow To continue
touch OK
Too much data was sent to the parallel port. Touch OK to clear the error message. (Data
will be lost.)
Check for a loose cable connection, and be
sure to use a high-quality cable. Some non-
HP parallel cables might be missing pin
connections or might otherwise not conform
to the IEEE-1284 specification. Go to
www.hp.com/support/LJM3027mfp or
www.hp.com/support/LJM3035mfp.
22 USB I/O buffer overflow To continue
touch OK
Too much data was sent to the USB buffer. Touch OK to clear the error message. (Data
will be lost.)
30.1.YY Scanner failure An error has occurred in the scanner. Turn the device off and then on.
If this message persists, contact an HP-
authorized service or support provider. (See
the HP support flyer, or go to
www.hp.com/
support/LJM3027mfp or www.hp.com/
support/LJM3035mfp.)
40 Bad serial transmission To continue
touch OK
A serial data error (parity, framing, or line
overrun) occurred as data was being sent by
the computer.
Touch OK to clear the error message. (Data
will be lost.)
40 EIO <X> bad transmission To continue
touch OK
The connection between the device and the
EIO card in the specified slot has been
broken.
Touch OK to clear the error message and
continue printing.
40 Embedded I/O bad transmission To
continue touch OK
A temporary printing error has occurred. Turn the device off, and then turn the device
on.
If this message persists, contact an HP-
authorized service or support provider. See
the HP support flyer, or go to
www.hp.com/
support/LJM3027mfp or www.hp.com/
support/LJM3035mfp.
41.3 - Load tray <XX> To use another tray,
touch OK
The specified tray does not contain the
specified media size.
Touch OK to use a tray that contains media
of the correct size.
41.3 - Load tray <XX>: <Type>, <Size> The specified tray is loaded with media that
is longer or shorter in the feed direction than
the size configured for the tray.
Touch OK to display Tray <X> Size.
Reconfigure the size in a tray so that the
device will use a tray that is loaded with the
size of media required for the print job. If the
message does not clear automatically from
the control-panel display, turn the device off,
and then turn the device on.
41.X Error To continue touch OK A temporary printing error occurred. Touch OK to clear the error. If the error is not
cleared, turn the device off, and then turn the
device on.
If this message persists, contact an HP-
authorized service or support provider. (See
the HP support flyer, or go to
www.hp.com/
support/LJM3027mfp or www.hp.com/
support/LJM3035mfp.)
Table 11-1 Control-panel messages (continued)
ENWW Control-panel messages 155