Filter
Top Products
Chapter 4 89
Test Controller
User interface
Table 21 Parameter Defaults
• 9=Display Test Configuration—Displays the current values of the
processor parameters. An example of the display is shown in the
example below. An asterisk denotes the current selections. For
Example, processor 0 is selected.
This minimum hardware requirements information is enclosed in
parentheses after the hardware type label and denotes the number of
that type required. In the example below, 1 processor, 1 PAC (the one
associated with the selected processor), and 1 MAC are needed.
The Test Controller compares the selected hardware components
versus these minimum requirements to determine if the test can be
executed. Unless these minimum requirements are met, the test
cannot be executed.
Parameter Default value
Loop Enable 0
Loop Count 0
Test Error Count 1
Pause At Test Start 0
Pause At Test End 0
Pause At Subtest Start 0
Pause At Subtest End 0