Filter
Top Products
26 Chapter 2
Configuration management
ts_config
Configuration Procedures
NOTE This procedure does not need to be performed unless the status shows
“Upgrade JTAG firmware.” If the node shows “Not Configured,” skip this
section.
The following procedures provide additional details about each
configuration action. ts_config automatically guides the user through
the appropriate procedure when a node is selected.
Active The node is configured and
answering requests on the
Diagnostic LAN.
None required. This is the desired
status.
Inactive The teststation node
configuration file contains
information about the specified
node, but the node is not
responding to requests on the
Diagnostic LAN.This status is
also shown if a node was
configured and then removed
from the teststation LAN
without being deconfigured.
Power-up the node and/or check for
a LAN connection problem. If the
node information shown is for a
node that has been removed, select
the node then select “Actions,”
“Deconfigure Node,” and click “Yes.”
Node Id
changed
The node is configured and
answering requests on the
diagnostic LAN, but the node ID
currently reported by the node
does not match the teststation
configuration information.
Select the node to obtain additional
information. If the node COP
information was changed to a
different node ID and the new node
ID is correct, select “Actions,”
“Configure Node,” then click
“Configure.” The teststation
configuration information is
updated using the new node ID.
Configuration
Status
Description Action Required