Filter
Top Products
110 Chapter 5
cxtest
Graphics interface
Powering down the system
When using cxtest in a troubleshooting environment, it is not
necessary to exit and enter cxtest each time the power is cycled.
To remove power to the system (for example, to move a board), power the
system down leaving cxtest running. Make sure that no tests are
actively running.
Once power is restored, POST returns control to the test controller in the
stand-alone mode. The user must also wait for the ccmd routine to
regenerate the database. A message will appear on the teststation
console stating the database generation is complete.
After the database is regenerated, the Boot Configuration map must be
read using the Command menu. If this is not done, cxtest will not have
the correct hardware configuration information.