Filter
Top Products
Chapter 2 29
Configuration management
ts_config
Figure 9 ts_config power-cycle panel
When the node is powered up, the “Configuration Status” should change
to “Not Configured.”
Configure a Node
Step 1. Select the desired node from the list of available nodes. When the node is
selected, the appropriate line is highlighted as shown in Figure 10.
Notice the bottom of the display indicates the Node 0 is not configured
and provides the steps necessary to configure the node.
Figure 10 ts_config indicating Node 0 as not configured
Step 2. Select “Actions” and then click “Configure Node,” as shown in Figure 11.