Filter
Top Products
2-8 Removal and Replacement HP Omnibook XT6050, XT/VT6200
Figure 2-7. Removing the Hard Disk Tray
Reassembly Notes
•
Carefully put the pin connector back onto the pins on the end of the new hard drive. Work at each
end alternately so that the connector slides on evenly without bending the pins.
•
Slide the cover down into place so the retainer tab engages the notebook case.
Important
If you are installing a new hard disk drive, load the factory software and operating system on the
drive as described in “Recovering the Factory Software,” below.
Pin connector
Screws, M3×3mm (2)
Screws, M3×3mm (2)
Screws, M2×4mm (2)