Filter
Top Products
3-30 Troubleshooting and Diagnostics HP Omnibook XT6050, XT/VT6200
Primary Video Adapter Sets whether the computer automatically switches to an
external video adapter connected to the docking system, if
one is detected.
Auto
Television Type Controls the signal format (NTSC or PAL) output by the
S-video port.
NTSC
System Memory Shows the system memory size. 640 KB
Extended Memory Shows the extended memory size (equals total memory size
minus 1 MB).
Detected
automatically.
Unique Dock ID Sets whether the computer creates a unique hardware profile
for each dock (Enabled) or uses a common profile for all
docks (Disabled).
Enabled
UUID Displays the value of the 16-byte UUID (Universally Unique
ID) as 32 hex characters.
Detected
automatically.
MAC Address Displays the internal LAN MAC address. Detected
automatically.
Serial Number Displays the serial number as it appears on the back of the
notebook.
Detected
automatically.
Service ID Displays the “Born On Date” stored in EEPROM in format
YYYYDDD.
Detected
automatically.
System Devices Menu Description Default
PS/2 Pointing Devices Disables the internal pointing devices when an external PS/2
mouse is connected.
Auto
FDD Controller Enables the floppy drive. Enabled
Legacy USB Support Enables BIOS support for USB mouse, keyboard, and floppy
disk drive.
Enabled
Internal LAN Enables the internal (wired) LAN. Enabled
Mini PCI Slot 1 Enables the PCI slot normally used for a wireless LAN. Enabled
Mini PCI Slot 2 Enables the PCI slot normally used for a modem, which is
located under the cover on the bottom of unit. (Does not affect
Ambit modem.)
Enabled
Serial port Enables the serial port. Enabled
Base I/O address Sets the I/O address. 3F8h
Interrupt Sets the interrupt. IRQ4
Infrared port Enables the infrared port. Disabled
Mode Sets the hardware to support FIR (Fast IR) or SIR (Standard
IR) infrared communications.
FIR
Base I/O address Sets the I/O address. 2F8h
Interrupt Sets the interrupt. IRQ3
DMA channel Sets the DMA channel for Fast IR (FIR) mode. DMA0
Parallel Port Enables the parallel port. Enabled
Mode Sets the port to output only, bi-directional, EPP, or ECP. ECP
Base I/O address Sets the I/O address. 378h
Interrupt Sets the interrupt. IRQ7
DMA channel Sets the DMA channel for ECP mode. DMA3