Filter
Top Products
HP Omnibook XT6050, XT/VT6200 Removal and Replacement 2-13
Removing the Keyboard
(HP Authorized Service Providers Only)
Required Equipment
•
Small Phillips screwdriver.
Removal Procedure
1.
Unplug the AC adapter, if present, and remove the battery and any secondary battery module.
2.
Remove the power button panel (page 2-11).
3.
From the bottom of the unit, remove the single screw marked with a “K.”
Warning
Be careful not to touch the heatsink until it has cooled. It could be hot if the computer was
running recently.
4.
Remove the four retaining screws from the tabs along the back end of the keyboard.
Figure 2-10. Removing the Keyboard
Caution
Be careful not to pull on the cables connecting the keyboard to the computer.
5.
Raise the back of the keyboard, then lift the keyboard out of the computer.
Screws, M2.5×6mm (2)
Screw, M2.5×17mm
Screw, M2×13mm
Screw, M2.5×6mm