Filter
Top Products
3 - 10
The I/O Connector
The I/O connector powers the terminal, charges the main battery, and facilitates communication. Dolphin
60s peripherals are designed to work exclusively with this connector. The I/O connector supports low,
full, and high speed USB v2.0 communication with a maximum rate of 480 Mbps.
Note: Signals referenced are for a DTE device.
Battery
The primary power source for the Dolphin 60s terminal is the 3.7V Li-ion rechargeable battery located
under the battery door on the back panel of the device. Honeywell recommends you keep the battery in
the terminal charged at all times to help prevent data loss. Letting the battery become fully discharged
causes the terminal to lose all data in RAM.
Note: All data in RAM is cleared when the battery is removed. Always Suspend the terminal before removing the
battery to ensure any changes made are saved to the flash memory.
Dolphin 60s model terminals are designed for use with battery part number 60s-BATT-1 (Li-ion 3.7 V,
12.358 watt hour) manufactured for Honeywell International Inc.
We recommend use of Honeywell Li-ion battery packs. Use of any non-Honeywell battery may result in
damage not covered by the warranty.
Charging Options
Dolphin terminals ship with the battery significantly discharged of power. The battery must be
completely charged for a minimum of 6 hours before using a Dolphin terminal for the first time.
When the main battery is installed in the terminal, use one of the following:
Pin Signal Pin Signal
1ADP_IN 9GND
2ADP_IN 10GND
3RXD 11GND
4TXD 12RTS
5 Cradle_EN 13 USB_DP
6 DTR 14 USB_DN
7 DC_5V_OUT 15 USB_VBUS
8CTS 16GND
123456789101112131416 15
!